ANT Forum

Hello everyone,

I am new to this ANT+ development. I have a GARMIN Edge 500 Cycling GPS, which has ANT+ function to receive messages from my heart rate monitor and speed/cadence sensor. So it seems like this Edge 500 is only an ANT+ signal receiver. My question is that does it transmit any ANT+ signal in the meantime?

I have one ANT+ development kit. I can use its USB interface board and AP2 module to receive messages from my heart rate monitor. I am thinking that in case the Edge 500 also transmits ANT+ signal, I can pick it up by using the USB board+AP2 module, right? If I can set up this connection, what are the configurations?

Thank you very much.      

You can find out what profiles are implemented by specific products in the Product Directory
http://www.thisisant.com/directory/edge-500/

It seems the Edge 500 only supports receiving data from heart rate, bike speed and cadence and bike power sensors.      

alejandra - 06 September 2013 08:28 AM

You can find out what profiles are implemented by specific products in the Product Directory
http://www.thisisant.com/directory/edge-500/

It seems the Edge 500 only supports receiving data from heart rate, bike speed and cadence and bike power sensors.

Yep, exactly.
@kale618: what would you expect the Edge500 to transmit, anyway??