ANT Forum

Hi,

Is there any specific divergence in the configuration with regard to the source examples (for the AP2 modules). The issue I'm having is that I implemented the state machine on the slave and it only appears to work if I set the channel assignment on the slave device to be a simple slave [0x00] (and not shared channel slave [0x20]).

All other configurations are the same as the examples (also note that the master device is configured as a shared channel master).

Am I missing anything?      

I've discovered what I'm doing wrong. Wasn't sending the broadcast message to set the shared address on the ant module.

I don't think the auto shared app note is sufficiently clear on this. It would have been beneficial to have a section explaining this in the app note (or at least point to the shared channel procedure in the protocol document).