ANT Forum

Hi,

I am using MSP430 to communicate with nRF24AP2. The board works well and we can successfully configure the ANT before. While yesterday, suddendly the RTS become to stay high sometime and now it is always high. According to the document, when I　power on the board, the ANT would reset by itself and RTS would become low. Now,just after the power up,without doing anything, when I check the pin, it is still high.

So, can I assume something is wrong with the board and I need to use another one to test?Thanks.      

Could you please tied the SLEEP signal to low and try again to see what you can get? If the problem still exist, we would like to review your schematic.