Hi, friend, I have got some problem in my RF project.
I use nRF24AP1 as the RF chip, and now I can send messages to it to reset,to assign channel, to set channel ID, to set ..., and to open channel, to send broadcast data or acknowledgemented data, and I have received the normal feedback, as RESPONSE_NO_ERROR, EVENT_TX, or EVENT_TRANSFER_TX_FAILED, etc. So I guess the ANT protocol engine in the chip works well.
The problem is the second node which I have configued as slave can't find the master (the transmitter), and I always got the message code EVENT_RX_SEARCH_TIMEOUT, and I have checked the parameters for more than two times and no error found.
I guess maybe the RF transceiver moduler in the chip can't work normally, or the there is something wrong with PCB layout of the antenna matching network?
I have got no Spectrum Analyzer, and therefore I have no idea of this problem, can anyone give me some ideas? thanks!
my configration for the master and slave nodes:
master node:
channel number:0
channel type: 0x10
network number:0
device number:1
device typeID:1
transmission type:1
slave node:
channel number:0
channel type: 0x00
network number:0
device number:0
device typeID:0
transmission type:0
