To setup the â??bit synchronous modeâ?, one example can be a reference as shown on the AP1 or AP2 module document â??ANTAP1MxIB RF Transceiver Moduleâ? or â??AP2 RF Transceiver Moduleâ?, which can be downloading from
http://www.thisisant.com/products/data-sheets-brochures
In the document, the â??Pin Assignmentâ? table describes more detail about the PIN definitions. For example,if set toâ??bit sync modeâ?, the DIP switches can be set as: DIP-2: PORTSEL=1 (tie to VCC), DIP-3: SFLOW =1 (tie to VCC).
The schematic also shows how many pins are required:
PIN3:SIN/RXD
PIN4:SOUT/TXD
PIN5:RTS/SEN
PIN9:SUSPEND/SRDY
PIN10:SMSGRDY/SLEEP
PIN19:BR2/SCLK
To implement the above pin definition, the rest switches on the battery board are tie to "VCC" as well.
How to connect the pin-outs to the different MCU is indeed userâ??s host controller independently. The principle is quite similar as this example.