ANT Forum

Hi,

I have been able to run the demo script and loading the scripts to ant modules works fine. The dump matches the original script.

When I connect the SensCore module to battery board and set the memsel to Vcc and iosel to gnd and all the rest to gnd nothing happens. None of the sample scripts works.      

The battery board settings you describe seem correct.
Are the modules you are using AT3 (two-chip)?
Do you see any change if pressing the reset button?

What are you using on the other side of the link?      

Yes, I'm using the two chip versions. The reset button does not make any difference.

In the demo mode the reset button works.      

Could you post the SensRcore script you are loading on your device, along with the configuration of the other side of the link?      

Now I managed to get it working.

Apparently with shared channel slave the shared slave address must be set and master does not support wild cards in the address.

B)