Home
ANT Forum

ANT Forum

Username		Password		Remember Me?	forgot password?

You are here: Forum Home → ANT Developer’s Forums → ANT General Questions → Thread

14 September 2010 03:05 AM

Johnny Ringo Sr. Member

Total Posts: 523

Joined 2012-11-15

Hi,

I have a setup where I connect a microcontroller (8051) with the battery board. And connecting an AP2 to the battery board 20-pin Molex.

I want to use byte synchronous SPI, and I wonder if the 20 pins on the board are mapped directly to the 20-pin molex? And if not where can I find this mapping?

And also what dipswitch settings to use?

Thanks!

14 September 2010 10:13 AM #1

kebinw Moderator

Total Posts: 55

Joined 2008-10-24

The battery board has mapped the 20pin head via with MCU. Please refer to the attached diagram. To match the byte synchronous mode,
the dip switchs should set as below:
1. SFLOW to GND
2. BR3 to GND
the reset tight to Vcc. [file name=Battery_board.pdf size=17008]http://www.thisisant.com/images/fbfiles/files/Battery_board.pdf[/file]

1 of 1 Pages

ANT Forum

Battery board interface