ANT Forum

Hi all,
I trying to use a ant plus example for heart rate tx which name is ant_hrm_tx_pca10040_s212 on nRF5_SDK and my board is nRF52 DK.
Althought I can build it and no error, and download to my board.
But still can not connect to my device, neither ANT stick nor Garmin watch.

Need any advice

Reference below:
SDK version:17.1.0
Software Device version: 6.1.1
SES version: V5.42a
Board: nRF52 DK(pca10040)

Sincerely

Grant      

geometry dash lite
Hi all,
I trying to use a ant plus example for heart rate tx which name is ant_hrm_tx_pca10040_s212 on nRF5_SDK and my board is nRF52 DK.
Althought I can build it and no error, and download to my board.
But still can not connect to my device, neither ANT stick nor Garmin watch.

Need any advice

Reference below:
SDK version:17.1.0
Software Device version: 6.1.1
SES version: V5.42a
Board: nRF52 DK(pca10040)

Sincerely

Grant

I think you should check the ANT channel configuration. Make sure your ANT channel configuration matches the requirements of the ANT+ device you're trying to connect to. The ANT+ device may have specific channel parameters that need to be set correctly, such as channel period, RF frequency, or channel type. Review the documentation of the ANT+ device to determine the required channel settings.      

You can use the nRF Connect tool to verify if the SoftDevice is present and check its version.
geometry dash razorleaf      

I recommend reviewing the ANT+ network key and channel setup in your code to ensure they match the settings required for your build now gg devices to communicate.      

Make sure your board is properly configured to work with ANT+. You need to enable the ANT+ features and configure the correct frequency, channel, aa route planner and related parameters.      

Enjoy Run 3 Unblocked game, a challenging and addictive game where you race through outer space tunnels. Play for free with no interruptions and sharpen your reflexes.