ANT Forum

Hello,

I have bought a module ANT11TS33M5IB see attached photos.
The module is not working. I would like to use it in Async Mode.
I connected as the manual shows but something wrong.
There is a LED on the board. When ligting the LED? After the supply power connection?
I tested the soldering contact and it is ok.
I use 3.3 Volt for supply.
I would communicate with USB to serial module. This module working correctly. It is communicating with an other module.
So, do you have any idea about the problem?
What is the minimum wiring to test the panel ANT11TS33M5IB?
Could you write some easy steps to check the panel? I would be sure it is not a scrap part.

Regards
Tamas
.(JavaScript must be enabled to view this email address)      

Hi,

Review your circuit against the schematic in section 2, Async Mode of the AT3 Transciever Module Datasheet .

I would also recommend reading the Interfacing with ANT General Purpose Chipsets and Modules document.

The on-board LED is controlled using serial messaging so it won't help you verify your power supply connection or whether the board is functional until you have established communication.
     

Ok. Now I'm sure the board is working. I received correct Event Messages.
Problem solving: after power on I had to switch a reset signal.

The next step I would like to do the test connection.
I have a USB2 Wireless USB Stick.
The ANTware II v.3.200 software identified it.

So my current question is, what is the most easy configuration to check the data transfer between the USB stick and my board (ANT11TS33M5IB)?

Regards
Tamas      

The easiest way to test both of the boards are set up correctly would be to configure your board as a master and have ANTWare configured as a slave to receive from it.

Make sure both of your ANT Nodes have their channels configured correctly as described in the ANT Pairing application note: (http://www.thisisant.com/resources/an02-device-pairing/)

     

I thank your help and patience.
Unfortunately the pairing is not working yet.
I tested two different modes see attached file.

I think the easiest way the simulated sensor. Because the sensor continuously sending the signals. But I can not pairing the two modules (USB2 Stick with ANT11TS33M5IB).

Could you send me some guidelines for sense of achievement?

Regards
Tamas      

Communication is OK .
Please do not reply to my previous post.

Regards
Tamas