Hello,
i have a little problem setting up a fore sensor properly with ant sensrcore.
its a simple fsr sensor that i want to use so i set up the ant module like this:
C [68][00][01] // Enabling LED on RF events
C [93][00][DA][00] // Setting A/D Sample Rate at 150 Hz
C [93][00][00][01] // Setting A/D Sample Rate at 128 Hz
C [91][00][00][41][00][01][00] // Configuring Data Channel 0 on ANT Channel 0 as Analog Input using pin(s) 00 reporting on 100.00% of messages
C [94][00][00][09][01][08][00][00] // Configuring Data Channel 0 A/D with reference setting of 9, sampling at 1.00 of sample rate, filter N value of 8
C [42][00][50][00] // Assign Channel Master Tx Only on ANT chanel 0 on network 0
C [51][00][31][00][01][05] // Assign Channel ID 0, Dev. Num = 49, Dev. Type = 1, Trans. Type = 5
C [43][00][00][08] // Set ANT Channel 0 Message Period to 16.00 Hz
C [45][00][42] // Set ANT Channel 0 RF Frequency to 2466 MHz
C [4B][00] // Open ANT chanel 0
the problem is, that the receiving end seems to skew a lot. whenever i push the sensor, the received data on the receive node changes about 1 - 2 seconds later...
what am i doing wrong?
thanx a lot
martin
