ANT Forum

Hi,

I'm following the documentation to build the demo programs for blaze, but cannot succeed. I use SDK 13 with the latest libraries and sample code. The build for np_gateway hex file is successfully built and flashed, but I cannot start gateway in Mesh Tester. I get a message about an ant USB device, when a node programmed with np_gateway is already attached.

What am I missing?

Thanks,
xuanjiao zhu      

Hi Xuanjiao,

The was the ANT USB Interface board successfully installed? It takes a little extra work to install them on Windows 10: https://www.thisisant.com/developer/resources/tech-faq/are-the-usb-drivers-supported-in-windows-10/      

I was not able to run the dome either. I also followed the steps in the ANT Blaze Starter Kit document, and the driver is installed successfully and I can see "ANT USB Device" under Universal Serial Bus Controllers tab of the Device Manager, and the driver provider is Silicon Labs Software, 2007-02-06, 3.1.0.0., not digitally signed.

Driver files are:

I'm not sure what is missing?

--Rasit

Harrison - 11 October 2018 04:37 PM

Hi Xuanjiao,

The was the ANT USB Interface board successfully installed? It takes a little extra work to install them on Windows 10: https://www.thisisant.com/developer/resources/tech-faq/are-the-usb-drivers-supported-in-windows-10/

     

Hi Rasit,

Were you able to get this working? As a little hack, you could also try installing "Garmin Express". I haven't isolated the registry changes it makes but it has resolved issues on systems before.