ANT Forum

Hi all,

My device uses a sparkfun nrf52832 with the ANT Network Processor built from sources with S340
This works quite well, I can send configuration messages to the ANT Network Processor and get the responses.

However when I put the value 0 or 1 in the RF frquency the system stop works. I try with others and works well. In the protocol the minimum value is 0, does the nrf52832 have a different minimum value? Where I can get this information?

Thanks for the help.      

Hi...Is that the entirety of your test program, or are you actually using something like the blinky example?Have you tried other pins, or is it only pin 10 that works?I suspect you have a hardware fault(s)?

pcb manufacturer       [ Edited: 29 May 2020 12:42 PM by RochLevoff ]